Rocom Doortello Home Podręcznik Użytkownika Pobierz pdf (Strona 5)

User guideDoortello HomeIssue 1.00

Page 5

Installation

Before you start with the installation please read the following indications:

- The Doortello Home can, together with his modular door station program, has

a IP 32 protection degree and can be installed also outside.

- If you plan an installation in a rainy environment we suggest the use of a

weather shelter or a surface mounting box with weather shelter (IP 33).

- If a fluid gets inside the unit disconnect at once the telephone line and the

external power supply (if installed).

- The device can only be maintained by instructed specialized technicians.

- Static discharges may damage the device. Please ensure that you are

grounded before any activity with the unit.

Please read carefully this user guide before you install the unit. Take care about

the security advices. Diregarding the warnings may be against existing laws or

cause dangerous situations.

Please note!

Think any time during installation at your own safety! Be careful and

disconnect the 230 V power supply before connecting the external power

supply unit. Before you touch any cable ensure that no voltage is present on

the line. Please consider that it can be against safety rules to run low and

high power cables in the same duct. An installation of 230 V cable inside the

door station is forbidden by law. If you have to drive high power circuits

with the internal driver contact of the device you have to use external high

power relais (like the 1471, see also the chapter Options)

For the flush and wall mounted installation of the device the modular Profilo

door station program has to be used. This program offers you a wide range of

different flush and wall mounting cases. More details about the installation of

the Doortello Business modular door station can be found in the documentation

delivered with the cases and modules.

Cabling of the chime buttons

The two chime buttons in the units DH 02, and the one in th DH 01, are hardwired

and cann't be modified. The expansion button 3 to 6 are connected to the

connectors P1 to P4. Each chime button has an decimal address from 1 to 6. Those

addresses are hardwired with each button or connector. The chime button 1, the

first from the bottom of the door phone module, has the address 1, the button 2,

the second from below, has the address 2, the connector P1 the address 3 and so

on the the connector P$ which has the address 6.

If you have the door phone DH 00 with no chime buttons, and one button modul

PL 11 with one button, this button will have the address 3, as far as it will be

connected to the connector P1.

Security advices

Flush and wall mounted installation

1 2 3 4 5 6 7 8 9 10 ... 31 32

Komentarze do niniejszej Instrukcji

Brak uwag

Rocom Doortello Home Podręcznik Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Domofony Rocom Doortello Home