Rocom Doortello Home Podręcznik Użytkownika Pobierz pdf (Strona 9)

User guideDoortello HomeIssue 1.00

Page 9

Programmation

The entire programmation, like storing the telephone numbers or the selection

of the different operating modalities, is done using a telephone with DTMF dial

capability.

Please note!

The device has two memories. A RAM and a flash memory. During the

programmation the unit will transfer all the data from the flash to RAM

memory. At the end of the programmation the data are transferred again

back to the flash. This will be done at one step when terminating the

programming mode using the digit 3. Pressing this digit you will get a

acknowledge tone, but the unit will disconnect the line and go back to

stand by only after some seconds. If during this time the line is interrupted

or the power will fail all the data programmed up this point will be lost. If

you are doing a larger programmation we suggest to make a data storage

from time to time.

Activate the programming mode

If you want to program the Doortello Home you have to first activate the

programming mode. Before you can program the device it has to be connected

to a telephone line and to a power supply.

After the first power on of the power supply the device will follow an

initialisation procedure. With this process the RAM memory is deleted and the

telephone line checked, read also the chapter First activation for more

information. During this time the device is not available. When the red LED will

go off the device is ready to be used.

Call now the unit using a phone with DTMF dial capability. The device will

answer the call and sent a short tone. The red LED will go on when the unit is

ready for speech.

Please note!

It may be that the automatic call answer feature has been deactivated on the

Doortello Home with a previous programmation.

In this case you will hear a ring back tone but the until will not answer the

call. To start the programming mode you have to press during the call one of

the chime or functional buttons at the door station. The device will now

answer the call and you can follow the programming procedure as

described.

The programming mode is activated with the following input:

*#0 Password (default 1234 ) OK tone

Now the programming mode is activated. The red LED is now flashing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Brak uwag

Rocom Doortello Home Podręcznik Użytkownika Strona 9